ten of cups

Applies to:

 Machine Operators.

Objective:

It is to provide the systematic procedure on how to operate and wash the waffle machine.

Policy or Handbook Reference

Refer to owner’s manual.

Pre-Requisites

Prior to use, inspect machine and electrical cords for visible damage

Step

Instruction

Illustration

Expected Result

Installation and Operating guide

1

Always make sure that the waffle maker is grounded before operating.

2

Connect the feed cable to the fuse

If available, the yellow warning light will be on to indicate that the appliance is connected.

3

Open switch and set thermostat to the cooking temperature of 275⁰C

The green lamp will turn on.

4

During short idle periods, do not turn off the product and keep it at the standby mode by setting the thermostat to 80⁰C

If you turn the grill plate off, then time and energy will be lost to reheat the cooled platinum plate sheet to the desired temperature for the next cooking operation)

5

After daily use, the grill plate should be closed by setting the thermostat to 0.

6

Cleaning guide

6 a

Always ensure that the waffle machine is disengaged from the main power supply before cleaning.

6 b

Waffle machine should not be cleaned with a water jet or dipped in water. Use only damp cloth or sponge dipped in soapy water.

6 c

Wipe off the waffle machine with a dry cloth and wait at least 30 minutes before reconnecting to the mains outlet.

7

Clean, wipe and wrap the waffle machine when done using it.

8

Do not use agents such as hydrochloric, Cif etc., to clean the appliance

Troubleshooting guide

9

1. Is the power switched OFF? The power should be ON.

2. Has a circuit tripped out? Re-set/repair as necessary.

3. Is the 3-pin plugged firmly into the wall socket? Check another appliance such as a toaster or kettle in the same socket.

Safety Instructions

10

1. When this warmer is to be positioned in close proximity to a wall, partitions, kitchen furniture, decorative finishes, etc. It is recommended that they must be made of non- combustible material for fire prevention. 

2. Ensure that the fire cord does not encounter hot surfaces.

3. If the supply cord is damaged, it must be replaced with a new cord assembly available from the supplier’s agent.

4. Use heat resistant gloves. Do not iron-ended spatulas.

5. Take care not to bump or drop the appliance during transportation.

6. Ensure that the fire cord does not encounter hot surfaces.

7. Do not leave unit in operation without an attendant.