ten of cups

Applies to:

 Machine Operators.

Objective:

It is to provide the systematic procedure on how to operate and wash the conveyor toaster.

Policy or Handbook Reference

Refer to owner’s manual.

Pre-Requisites

Prior to use, inspect machine and electrical cords for visible damage

Step

Instruction

Illustration

Expected Result

Installation and Operating guide

1

Lower the front heat shield all the way down, leave just enough clearance for bread slices to pass under the shield into the cooking cavity.

2

Turn top and bottom heat controls to HI; turn conveyor speed control to 50.

3

Allow warm up time of 5 to 10 minutes.

4

Test with a slice of bread.

1. If toast is too light, turn conveyor speed control counter clockwise to a slower speed.

2. If toast is too dark, turn conveyor speed control clockwise to a faster speed.               

Cleaning guide

5

Turn top and bottom heat controls to the OFF position.

6

For lightly soiled conveyor belts, turn conveyor speed control to fastest setting (100) and wipe with a damp cloth.

7

For heavily soiled conveyors, turn conveyor speed control to fastest setting

(100) and wipe with a light abrasive pad.

8

Turn conveyor speed control off.

9

After the unit cools, remove interior crumb tray and clean.

Slide crumb tray back into position. DO NOT OPERATE UNIT WITHOUT

CRUMB TRAY IN PLACE AS THIS CAUSES OVERHEATING IN THE

CONTROL BOX AND MAY ACTIVATE THE HEAT LIMIT SWITCH.

10

Wipe exterior surface of unit.

Troubleshooting guide

11

Unit will not heat, conveyor will not turn.

1. Be sure the main circuit breaker is switched to the ON position.

2.  Check to see if the toaster is plugged in and all controls are turned to the ON position.

12

Unit will not heat, conveyor turns properly.

1. Check to see if both top and bottom heat controls have been turned to HI.

2.  Push heat limit switch on front of control box.

13

The heat limit switch is activated when there is not sufficient air flow generated by the cooling fan. When heat limit switch has been activated:

1. Disconnect unit from the power source.

2. Check to see if air intake area in the bottom centre of the control box cover is free of dust, grease or other obstructions.

14

Check if crumb tray is in place. NEVER OPERATE UNIT WITHOUT

CRUMB TRAY IN PLACE AS THIS CAUSES OVERHEATING IN THE CONTROL BOX.

Safety Instructions

15

1. If the supply cord is damaged, it must be replaced with a new cord assembly available from the supplier’s agent.

2. Take care not to bump or drop the appliance during transportation.

3. Ensure that the fire cord does not encounter hot surfaces.